The Quickroll Lite banner uses the same reliable, slimline base with two twist-out feet as our budget roll banner but comes as standard with a scratch resistant laminated graphic panel.

The graphic on the Quickroll Lite banner is printed using new HP Vivera lightfast inks at an astonishing 2440dpi onto a completely opaque polyester film specifically designed for use with roller banners.

The 'Opal Jet' polyester film has a thickness of 125 microns and is over-laminated with a scratch resistant 125 micron film to give a finished graphic thickness of 250 microns. The scratch resistant crystal film gives a superb, uniform finish to the printed graphic which will resist minor scratches and scuffs.

The Quickroll Lite banner takes only a minute to assemble and is supplied complete with a padded carry bag for easy transportation.

 Sizes Available:  600mm and 850mm

Artwork Requirements - design templates are also available from our download tab above

Size: 850mm wide x 2150mm page size.

or

Size: 600mm wide x 2150mm page size.

Resolution: We suggest no less than 150dpi at full size. Please increase resolution accordingly to allow  for any enlargement should you set artwork at a reduced-scale.

Colour Mode: Supply artwork in CMYK mode only

Important Info: The bottom 200mm of the 2150mm page height is non-viewable and you should ensure that all viewable information is raised up, above this region of the artwork. We suggest that the  background colour or any background images run all of the way into the non viewable  region, down to the bottom of the page.

Files types supported: Please save files as JPG, Tiff or PDF