Curvorama graphics panels are available with a choice of straight or flexible fixing rails and a choice of 600mm or 800mm width. The height of all Curvorama panels is 2200mm tall. The panels will require a support pole and feet in order to be free standing or alternatively they can be used with shell scheme fixings should you wish to hang them from a pre-existing shell scheme wall.
Both the free standing poles and feet or shell scheme fixings are available separately from the accessories links at the bottom of this page or alternatively you can find them on the Curvorama section on our website. Please note that you will need one set of fixings for each Curvorama graphic that you purchase (if you want to use them at the same time).
Curvorama graphic panels are printed onto a 240 micron non-curling display film which allows the panels to hang flat in any indoor environment. It is possible to display several Curvorama graphics side by side without having gaps in between in order to create a large display backwall.
Our friendly team are here to help with any questions you may have regarding Curvorama so if you wish to run through your requirements, have any questions or need an obligation free quote then please call or email and we can help.
Artwork Set Up Requirements -
If you are supplying artwork for multiple panels that are to be tiled side by side then the artwork should be prepared in one spread that we will break up into separate panels for printing. For example, if you require three 800mm wide Curvorama panels then the final artwork size would be 2200mm tall by 2400mm wide (plus the bleed area)
- Colour mode - Please set artwork in CMYK colour mode only
- Size - 2200 x 600 or 800mm (depending on required panel width)
- Bleed - Please allow 10mm of printed edge bleed and set artwork with crop marks
- Artwork Formats - PDF, JPG, TIFF