Curvorama and Showsuit adapter clips are designed to hook-onto the cross beams of most major metal exhibition shell schemes.
Standard adapter clips require a small amount of clearance underneath the bottom of the shell scheme post so you can physically hook the plastic clip underneath.
Although it is normal for most shell scheme contractors to allow a small gap of around 15mm or so underneath the bottom cross beam of a shell scheme, it can be the case the some contractors physically sit the beam on the floor. This can present a problem because the regular plastic adapter cannot fit underneath.
Although it is possible to lift-up the cross beam by undoing it (usually a hex key is required) we have an optional spring clip that is small enough to squeeze under a shell scheme beam even if it is sitting on the floor.
These clips can also be used to hook-into the slot on the top beam of a shell scheme if the beam itself is too wide for the regular Curvorama or Showsuit adapter clip.
The clips are sold as a pack of two.
Two clips would be required to hook onto the bottom beam of each 1M section of Showsuit graphics or per Curvorama panel and two clips would also be required (if needed) for the top beam